![]() One of the decos is connected via WiFi as I didn’t have a handy Ethernet port other than through a power line adapter which was rubbish. Over 30 devices connected via Wi-Fi or Ethernet. I have 4 Decos with the same firmware version as mentioned in the previous post. Might be a bit late in the day, but I’ve just noticed this thread. I will try tonight with a different TP-Link switch (TL-SF1005D) that I have at home, although this is not ideal as it is 10/100Mbps. I reached out to TP-Link technical support but they were apparently unaware of the issue and this is when I found this post. Same, if I remove the switch from the setup and connect directly the 2 decos via my ethernet network it works fine.Īnyone knows if any fix has been identified as this issue seems to have been going on for some months ? (apart from buying a switch from TP-Link ) Modem > deco #1 > d-link switch > computer works fine with 2 different computers on 2 outputs of the switch. Issue does not come from the switch of my network as Modem > deco #1 > d-link switch > deco #2 and both units start alternating between green and blinking red when I connect them. I set-up deco #2 wirelessly next to deco #1 and it works fine. 47257) and I use a D-Link unmanaged switch (GO-SW-8G). Latest firmware to date (1.1.6 Build 20171103 Rel. Same issue on my side with 2 Deco units (haven't tried with the third one yet as I seriously considering returning these).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |